EXCLUSIVLY SOLD THROUGH ROWDY ROMANS ESTY STORE!
www.etsy.com/shop/rowdyromanfire
 
Stop the struggle of seeing where exactly the bit is in relation to your material!!

Here is the 65mm router and 80mm spindle light. Super easy to install!!

It comes with a fully threaded replacement bolt for the router clamp. Just pop off the bottom bolt that holds the router and slide the light onto your router and hand tighten the light onto your Onefinity.

This item comes with everything put together and ready for installation.

Cord length is approximately 10 feet and comes with a 110v standard American plug

Here is a link to a beta testers review: https://forum.onefinitycnc.com/t/another-bright-idea-from-rowdyroman-led-router-light/5192

As suggested on the above review this can be installed into a relay which would allow the light to turn off when the project is complete

IMPORTANT NOTE: THE LIGHT MOUNT USES A RIVET NUT WHICH EXPANDS IN THE 3D PRINTED PART. DO NOT USE A DRILL TO TIGHTEN THE LIGHT MOUNT TO THE ONEFINITY!!!! USE THE ALLEN KEY TO INSTALL. YOU CAN STILL TIGHTEN IT PRETTY HARD BUT BEWARE THAT IF YOU EXPAND THE RIVET NUT TOO MUCH YOU WILL CRACK THE 3D PRINTED PART. GOOD PRACTICE IS TO USE THE LONG END OF THE ALLEN KEY INSERTED INTO THE BOLT AND THE SHORT END OF THE ALLEN KEY AS YOUR TORQUE
 
 
Check out the video here: https://www.youtube.com/watch?v=bh6BUmEBGmI&t=13s